Multi-Holder
Design 42
Reason for existance?
The Multi-Holder is designed to work seamlessly with deck products such as chamois mops, brushes, foam blades, pole extensions, boat hooks, doodle pad heads and any other product that utilizes the same pin mechanism. This will let you use space more effectively and struggle less.
How does it work?
All you have to do is screw in and/or stick your holder wherever you like and let your adhesive pads (if used) set for 24 hours before adding tools.
Next, simply line up the pin of your tool you'd like to hold with the groove and insert your product till the it clicks into place.
To remove it, simply pull it down and out of the holder.
Multi-holder features.
There are four holes premade for screws at the corners so you can install it onto starboard or fiberglass without worrying about it falling off.
The holes for your screws are already made with a counter sunk so as to save you time and have it look more professional.
85mm
85mm
Made with a large 85x85mm smooth base there is plenty of area to apply adhesives or double sided tape to ensure that you holder does not fall off.
What comes with every purchase?
-
1x Multi-Holder
-
4x Screws
-
4x M3 VHB Double sided pads
-
1x Instructional card
ATTENTION - 3D PRINTED
These products are 3D printed at the moment and I will have them injection molded at a later stage.
Please dont think that because they are 3D printed they are weak, I've been using them for the last 6 months and haven't had them wear out yet.
I have done a 24 hour stress test by hanging a bucket with 3 gallons of water in it, on the holder and it held without any issues.
